Grounding - Mitsubishi Electric MELSERVO-J3 Series Manual

4. SIGNALS AND WIRING

4.12 Grounding

WARNING
The servo amplifier switches the power transistor on-off to supply power to the servo motor. Depending on the
wiring and ground cable routing, the servo amplifier may be affected by the switching noise (due to di/dt and
dv/dt) of the transistor. To prevent such a fault, refer to the following diagram and always ground.
To conform to the EMC Directive, refer to the EMC Installation Guidelines (IB(NA)67310).
NFB
(Note)
Power supply
Note. For 1-phase 200 to 230VAC or 1-phase 100 to 120VAC, connect the power supply to L
There is no L for 1-phase 100 to 120VAC power supply. Refer to section 1.2 for the power supply specification.
3
Ground the servo amplifier and servo motor securely.
To prevent an electric shock, always connect the protective earth (PE) terminal
(terminal marked ) of the servo amplifier with the protective earth (PE) of the
control box.
Control box
Protective earth(PE)
Servo amplifier
CN2
MC
L
1
L
2
L
3
L
U
11
L
21
V
W
CN3
Outer
box
4 - 53
Servo motor
Encoder
U
V
W
Ensure to connect it to PE
terminal of the servo amplifier.
Do not connect it directly to
the protective earth of
the control panel.
L and leave L open.
1 2 3
M