Installing 3300 Analog Service Units; Install An Asu - Mitel 3300 Technician's Handbook

Technician's Handbook

Installing 3300 Analog Service Units

Install an ASU

This procedure applies to both the ASU and the
Universal ASU. You can connect up to four ASUs or
Universal ASUs to the Controller.
1. Mount the ASU.
2. Connect a Cross-over Category 5 cable with RJ-45
3. Complete telephony cabling (see Table 16 on
4. For the Universal ASU, complete the Music on Hold
5. Connect power to the ASU.
44
Note: Ensure that there is a free CIM port on the
Controller.
Note: The following IP addresses are reserved for the
ASUs:
192.168.10.1 to 192.168.10.3
192.168.11.1 to 192.168.11.3
192.168.12.1 to 192.168.12.3
192.168.13.1 to 192.168.13.3
connector to the CIM port on the ASU and a free CIM
port on the Controller (see Table 11 on page 33).
Note: The 3300 Universal ASU can be located up to
30 meters (98.4 feet) away from the 3300 Controller. The
interface employs a single standard 8-pin modular jack
consisting of 2 balanced signal pairs and is located on
the front of the unit.
page 46).
and Paging cabling if required (see Table 17 and
Table 18 on page 47).
Once the CIM link synchronizes, the CIM LEDs turn
on. The Controller detects the ASU, and the
application software downloads and starts
immediately.
Note: The unit will be in an abnormal operation mode until
all the programming is complete.