Programming - Mitel SX-5 Manual

P r o g r a m m i n g
SECTION MITL9103-098-105-NA
Description
The SX-5 contains a default program with a fully operational customer feature
package. This default data will fill most customer's needs. However, some re-
programming may be necessary to fulfill a specific customer's requirements. Program-
ming is performed by dialing digits from the Control Extension (EN
1).
Table 4 lists the
customer programs that may be modified.
T a b l e 4
P r o g r a m m i n g
Conditions
'
To enter the programming mode, System Switch 2 (SW2) must be set to OPEN.
Programming is performed from the Control Extension only.
Only one parameter can be changed at a time.
If incorrect digits are dialed, reorder tone is returned.
If correct digits are entered and the state of the customer's data is changed
Acknowledge Tone 1 is returned.
If correct digits are entered and the state of the customer's data is not
changed Acknowledge Tone 2 is returned.
All Feature Access Codes are fixed.
Extension features are inherent and cannot be disabled.
For fwther programming information, refer to Section MlTL9103-098-205-NA,
Pmgramm ing.
Feature Selection
P r o g r a m m a b l e D a t a
Extension Characteristics
System Timers
System Selection
Trunk Characteristics
Nationality (Numbering Plans, etc.1
Toll Restriction
To Program the System:
Set SW2 to OPEN.
.
Lift the Control Extension handset
-
dial tone is returned.
Dial the required programming digits
-
acknowledge tone is returned.
Replace the handset
Set SW2 to CLOSED.
A c c e s s Code
40
41
42
43
44
45
NOTE:
Acknowledge tone may be one of two tones; they are:
One beep none
1).
indicates that the new feature access code has been
accepted.
Two beeps none 2). indicates that the feature was already selected.
The relevant tone is repeated three times. Reorder tone will be received
when the dialed code is invalid.
P a g e 43