Table of Contents
Advertisement
• Upload user defined method — This method can be found in the following folder:
To automatically set the standby function after sequence end
In the Sequence Options of an Isodat Software Suite Software Suite sequence there are two boxes.
See
Figure 132. Sequence Standby Options
• ConFlo IV Standby after Sequence — Reduces the helium flow in the ConFlo IV to a
Thermo Scientific
C:\Thermo\Isodat NT\Global\User\ConFlo IV Interface\EA IsoLink Device\Method\Flash Default
The method can be modified to your purposes. Alternatively, it can be created a new by
renaming the given EA file name (EA Stdby Setting.eam)
Note If the method does not exist in the given folder Isodat Software Suite uses the default
settings for the EA (reduced gas flow options)
minimum required to protect the ion source from ingress of air through the Open Split. The
following action are taken:
–
The ConFlo is set into LF Mode.
–
The sample dilution is set to V1.
–
All reference gases are closed.
–
Reference dilution is set to zero.
EA IsoLink IRMS System for CNSOH Operating Manual
7
Maintenance
Post-Analysis Operations
121
Hide quick links:
Advertisement
Table of Contents
