Thermo Scientific EA IsoLink IRMS System Operating Manual page 129

Note Usually, the printout of results is not performed until the complete measurement has
been finished. Therefore, it is recommended to choose No Printout.irw on the Printout@H2
page. Printout options are best defined at the end of the Printouts page.
20. Click the tab Evaluation@CO. See
Figure 112. Evaluation@CO Page of the Dual Measurement Method
21. Set the Evaluation@CO parameters for your new dual measurement method as shown in
Figure
22. 3.Click the tab Peak Detection@CO, see
Figure 113. Peak Detection@CO Page of the Dual Measurement Method
Thermo Scientific
112.
6
Figure 112.
Figure 113.
EA IsoLink IRMS System for CNSOH Operating Manual
Using EA IsoLink IRMS System for CNSOH
Setting Up a HO Method
101