Switchs 3; Toggle Switch For Two-Wheel Drive Or Four-Wheel Drive - Segway Villain SX10 Owner's Manual

Switchs 3

Toggle Switch for Two-Wheel Drive or Four-Wheel Drive

drive. This mode is suitable for vehicles driving on flat roads.
4 x 4 patterns
When the two-four-wheel drive switch (4-wheel drive switch) is pressed, the symbol
" " of 4-wheel drive is displayed on the instrument. At this time, the instrument
is in the state of 4-wheel drive, with power output of the front wheel and power
output of the rear wheel. This mode is suitable for muddy conditions, mountainous
conditions and other bad road conditions.
4×4 locking mode
When the two-four-wheel drive switch (4-wheel drive switch) is pressed, the four-
wheel drive lock symbol "
four-wheel drive lock is working in the state of 4-wheel drive lock. The front wheel
has power output, the rear wheel has power output, and the left and right tires of
the rear wheel output the same speed and power. The vehicle will in speed limitation
and speed cannot more than 18 MPH (30km/h), this mode is suitable for vehicle in
troubles. The speed limit can be released through the Override Switch"
1
Emergency Stop Switch
2
Torque Switch
Emergency Stop Switch
" " Engine Start
" " Engine Stop
torque switch
!
" " Lift the max speed limit of the
vehicle in 4WD-LOCK mode ( 18.6MPH
(30KM/h))
" is displayed on the instrument. At this time, the
2-6
1
Handle Switch
2 x 4 patterns
When the two-four-
wheel drive switch is
in the two-wheel drive
state, the whole vehicle
is only driven by the rear
wheel, and the front
wheel has no power
output. The meter
shows the symbol
" " for the second
!
".