Indicator Lights - Polaris RANGER EV 2015 Service Manual

ELECTRICAL

INDICATOR LIGHTS

The indicator lights can activate only when the key is in the ON position. See Table 1.
INDICATOR STATUS
Steady
Malfunction
Flashing
Steady
Park Brake
Steady
Gear Position
Flashing
Motor / Controller
High Temperature
Steady
NUMBER OF
BLINKS CODE DEFINITION
Data or configuration error
1
Sequence fault
2
3 Power fault
4 Contactor fault
Motor speed or throttle input error
6
CODE NUMBER CODE NAME
P1B14 STC Two Direction
Fault
P1B15 STC SRO Fault
P1B16 STC Sequencer Fault Sets if vehicle is keyed on in F or R, or if F or R is selected before contactor closes.
P1B17 STC FS1 Recycle
Fault
P1B62 STC Hand Brake
Fault
8.14
INDICATES
Key turned ON with Direction Selector in FORWARD or REVERSE. Move direction
selector switch to neutral, then back to forward or reverse. NOTE: If accelerator pedal is
depressed when key is turned ON, MIL will illuminate until pedal is fully released.
Electrical Malfunction. Light on Controller will blink a flash sequence. See Table 2 for
description of Blink Codes.
Park brake engaged. Move lever forward to fully released position or inspect switch.
Drive motor will not receive power until park brake light is OFF.
F, N, or R will illuminate depending on position of the Direction Selector Switch.
Reduced performance due to elevated temperature.
Power delivery terminated to prevent damage from overheating.
NUMBER OF
BLINKS
7
8
12
13
COMMENTS
(SEE DIGITAL WRENCH TROUBLE CODE LIST, PAGE 8.38 FOR A
COMPLETE LIST OF CODES AND DIAGNOSTICS)
Sets if both forward and reverse switches have been active simultaneously for
greater than 200ms. Check vehicle wiring and reset switches. Can also be set if
vehicle is driven to battery voltage level below 32 volts.
Sets if FS1 (accelerator pedal) is on in Neutral for more than .1 seconds. Cycle key
switch OFF-ON with pedal released.
Cycle key OFF-ON in Neutral.
Sets if accelerator pedal (foot switch) is not released completely during a direction
change. Cycle key OFF-ON.
Parking brake switch active (parking brake applied or brake switch contacts are
closed). Release brake / test switch.
CODE DEFINITION
Voltage protection
Controller or motor out of temperature
range
Communication error
Software fault
9926595 R01 - 2015-2016 RANGER EV Service Manual
© Copyright Polaris Industries Inc.