Table of Contents
Advertisement
After pressing
I
18.
Press the
"melody-chime".
In "melody chime" mode when a chime zone is triggered, chime melody is
heard
19.
Press
I
OK
[DEV SETTINGS].
You can now press the
or press the
I
OK
Accessories Guide for instructions), or press the
"
".
<OK> TO EXIT
4.5 Siren Configuration
4.5.1 Configuring the Length of Time the Bell is Allowed to Function
Here you select the length of time the bell (or siren) is allowed to function upon alarm. The bell time starts upon activation
of the siren. Once the bell time expires, the siren is automatically shut down.
Available options are: 1, 3, 4 (default), 8, 10, 15 and 20 minutes.
Note: To comply with EN requirements, the Bell Time should be set to 15 min. max.
To Configure the Length of Time the Bell is Allowed to Function
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
2.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
The screen will now prompt you to enter your installer code.
3.
Enter your Installer Code.
4.
Press the
option.
5.
When the PowerMax10-G2 display reads [DEFINE PANEL], press
The PowerMax10-G2 display will read [01:ENTRY DELAY 1].
6.
When the PowerMax10-G2 display reads [01:ENTRY DELAY 1], press the
or
7.
Press
and make the selection and then press
I
OK
The PowerMax10-G2 display will revert to [04:BELL TIME].
You can now press the
"
" or press the
DEFINE PANEL
4.5.2 Enabling the Internal Siren
Here you determine whether the internal siren will sound or remain silent upon alarm (according to the user preference).
Options: piezo siren on (default), piezo siren off.
To Enable the Internal Siren
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
2.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
D-302756
, the PowerMax10-G2 display will read [chime OFF
OK
and
buttons to select between "CHIME OFF" and
to
confirm.
The
PowerMax10-G2
button to modify the next device of the same type,
button to configure the parameters of the device (see the
or
button repeatedly and select the [DEFINE PANEL]
button repeatedly until the display will read [04:BELL TIME].
or
button to take you to "
display
button to take you to
to confirm.
I
OK
button to program any other menu in
<OK> TO EXIT
].
will
read
button
.
I
OK
I
OK
".
button
.
I
OK
Chime OFF
or
melody-chime
I
OK
Z01:DEV SETTINGS
READY 00:00
INSTALLER MODE
I
OK
ENTER CODE:
CODE
or
DEFINE PANEL
I
OK
01:ENTRY DELAY 1
or
04:BELL TIME
I
OK
SELECT OPTION
I
OK
04:BELL TIME
READY 00:00
INSTALLER MODE
19
Advertisement
Table of Contents
