Table of Contents
Advertisement
4.
Press the
option.
5.
When the PowerMax10-G2 display reads [DEFINE PANEL], press
The PowerMax10-G2 display will read [01:ENTRY DELAY 1].
6.
When the PowerMax10-G2 display reads [01:ENTRY DELAY 1], press the
or
CANCEL].
7.
Press
and make the selection and then press
I
OK
The PowerMax10-G2 display will revert to [06:ALARM CANCEL].
You can now press the
"
" or press the
DEFINE PANEL
4.7.5 Configuring Power Failure Threshold Period
Here you determine the time interval between AC power failure occurrence and the failure reporting.
Options: 5 minutes (default), 30 minutes, 60 minutes or 180 minutes.
Note: To comply with EN requirements, set to 60 min. max.
To Configure the Power Failure Threshold Period
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
2.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
The screen will now prompt you to enter your installer code.
Enter your Installer Code.
3.
4.
Press the
option.
5.
When the PowerMax10-G2 display reads [DEFINE PANEL], press
The PowerMax10-G2 display will read [01:ENTRY DELAY 1].
6.
When the PowerMax10-G2 display reads [01:ENTRY DELAY 1], press the
or
REP].
7.
Press
and make the selection and then press
I
OK
The PowerMax10-G2 display will revert to [34:AC FAIL REP].
You can now press the
"
" or press the
DEFINE PANEL
4.7.6 Configuring Abort Time
Here you select the length of time allowed by the system to abort an alarm (not applicable to alarms from FIRE, 24H SILENT,
EMERGENCY, GAS, FLOOD and TEMPERATURE zones). The PowerMax10-G2 is programmed to provide an "abort interval"
that starts upon detection of an event. During this interval, the buzzer sounds a warning but the siren remains inactive and the
alarm is not reported. If the user disarms the system within the allowed abort interval, the alarm is aborted.
40
or
button repeatedly and select the [DEFINE PANEL]
button repeatedly until the display will read [06:ALARM
or
button to take you to "
or
button repeatedly and select the [DEFINE PANEL]
button repeatedly until the display will read [34:AC FAIL
or
button to take you to "
to confirm.
I
OK
button to program any other menu in
<OK> TO EXIT
to confirm.
I
OK
button to program any other menu in
<OK> TO EXIT
I
OK
".
button
.
I
OK
I
OK
".
CODE
or
DEFINE PANEL
I
OK
01:ENTRY DELAY 1
or
06:ALARM CANCEL
I
OK
SELECT OPTION
I
OK
06:ALARM CANCEL
READY 00:00
INSTALLER MODE
I
OK
ENTER CODE:
CODE
or
DEFINE PANEL
I
OK
01:ENTRY DELAY 1
or
34:AC FAIL REP
I
OK
SELECT OPTION
I
OK
34:AC FAIL REP
D-302756
Advertisement
Table of Contents
