Table of Contents
Advertisement
To Configure the Jamming Detection
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
2.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
The screen will now prompt you to enter your installer code.
Enter your Installer Code.
3.
4.
Press the
option.
5.
When the PowerMax10-G2 display reads [DEFINE PANEL], press
The PowerMax10-G2 display will read [01:ENTRY DELAY 1].
6.
When the PowerMax10-G2 display reads [01:ENTRY DELAY 1], press the
button repeatedly until the display will read [19:JAM DETECT].
You can now press the
"
" or press the
DEFINE PANEL
7.
Press
and make the selection and then press
I
OK
The PowerMax10-G2 display will revert to [19:JAM DETECT].
You can now press the
"
" or press the
DEFINE PANEL
4.7.10 Configuring Whether a Missing Device Causes the System to Become
"NOT READY"
Here you determine if the system will be in NOT READY status when there is a supervision failure. In the "in supervision"
mode, the system will be in NOT READY status if during the last 20 minutes a supervision message was not received.
Options: normal (default) and in supervision.
Note: To comply with EN requirements, "in supervision" must be selected.
To Configure whether a missing device causes the system to become "NOT READY"
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
2.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
The screen will now prompt you to enter your installer code.
Enter your Installer Code.
3.
4.
Press the
option.
5.
When the PowerMax10-G2 display reads [DEFINE PANEL], press
The PowerMax10-G2 display will read [01:ENTRY DELAY 1].
6.
When the PowerMax10-G2 display reads [01:ENTRY DELAY 1], press the
or
D-302756
or
button repeatedly and select the [DEFINE PANEL]
or
button to take you to "
or
button to take you to "
or
button repeatedly and select the [DEFINE PANEL]
button repeatedly until the display will read [16:NOT READY].
button to program any other menu in
<OK> TO EXIT
to confirm.
I
OK
button to program any other menu in
<OK> TO EXIT
button
.
I
OK
I
OK
".
".
button
.
I
OK
I
OK
READY 00:00
INSTALLER MODE
I
OK
ENTER CODE:
CODE
or
DEFINE PANEL
I
OK
01:ENTRY DELAY 1
or
19:JAM DETECT
I
OK
SELECT OPTION
I
OK
19:JAM DETECT
READY 00:00
INSTALLER MODE
I
OK
ENTER CODE:
CODE
or
DEFINE PANEL
I
OK
01:ENTRY DELAY 1
or
16:NOT READY
43
Advertisement
Table of Contents
