Table of Contents
Advertisement
3.
Enter your Installer Code.
4.
Press the
option.
5.
When the PowerMax10-G2 display reads [DEFINE PANEL], press
The PowerMax10-G2 display will read [01:ENTRY DELAY 1].
6.
When the PowerMax10-G2 display reads [01:ENTRY DELAY 1], press the
or
Press
and make the selection and then press
7.
I
OK
The PowerMax10-G2 display will revert to [09:EXIT MODE].
You can now press the
"
" or press the
DEFINE PANEL
4.8.2 Configuring Entry Delays Duration
Two different entry delays allow the user to enter the protected site (while the system is in the armed state) via 2 specific
doors and routes without causing an alarm.
Following entry, the user must disarm the control panel before the entry delay expires. Slow-rate warning beeps start
sounding once the door is opened, until the last 10 seconds of the delay, during which the beeping rate increases.
Locations No. 1 (entry delay 1) and 2 (entry delay 2) allow you to program the length of these delays. Available options for
each delay are: "00s", "15s" (default for entry delay 2), "30s" (default for entry delay 1), "45s", "60s", "3m" and "4m".
Note: To comply with CP-01 requirements, "
Note: To comply with EN requirements, the entry delay must not exceed 45 sec.
Note: To comply with UL requirements, the entry delay must not exceed 15 sec.
To Configure the Duration of the Entry Delays
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
2.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
The screen will now prompt you to enter your installer code.
3.
Enter your Installer Code.
4.
Press the
option.
5.
When the PowerMax10-G2 display reads [DEFINE PANEL], press
The PowerMax10-G2 display will read [01:ENTRY DELAY 1].
6.
Press the
button once for [02:ENTRY DELAY 2].
7.
Press
and make the selection and then press
I
OK
The PowerMax10-G2 display will revert to [01:ENTRY DELAY 1].
You can now press the
"
" or press the
DEFINE PANEL
D-302756
or
button repeatedly and select the [DEFINE PANEL]
button repeatedly until the display will read [09:EXIT MODE].
or
button to take you to "
00s
or
button repeatedly and select the [DEFINE PANEL]
or
button to take you to "
to confirm.
I
OK
button to program any other menu in
<OK> TO EXIT
" and "
" options are not available.
15s
to confirm.
I
OK
button to program any other menu in
<OK> TO EXIT
I
OK
".
button
.
I
OK
I
OK
".
ENTER CODE:
CODE
or
DEFINE PANEL
I
OK
01:ENTRY DELAY 1
or
09:EXIT MODE
I
OK
SELECT OPTION
I
OK
09:EXIT MODE
READY 00:00
INSTALLER MODE
I
OK
ENTER CODE:
CODE
or
DEFINE PANEL
I
OK
01:ENTRY DELAY 1
02:ENTRY DELAY 2
I
OK
SELECT OPTION
I
OK
01:ENTRY DELAY 1
45
Advertisement
Table of Contents
