Table of Contents
Advertisement
A. ZONE
B. TAMPER
C. ALARM
Note: Do not use mains cable other than that supplied by the manufacturer (3 m long).
4.4.4 Deleting a Device
C. To Delete a Device
Repeat steps 1 to 5 in section 4.4.3 "Adding a Device".
1.
When the PowerMax10-G2 display reads [ADD NEW DEVICES] press the
2.
button.
The PowerMax10-G2 display will read [DELETE DEVICES].
3.
Press
.
I
OK
The PowerMax10-G2 display will read [CONTACT SENSORS].
4.
Press the
deleted. Select between "CONTACT SENSORS", "MOTION SENSORS", "SMOKE
SENSORS", "WIRED SENSORS", "KEYFOBS", "SIRENS" and "REPEATERS" for
example, "MOTION SENSORS".
5.
Press the
I
OK
The PowerMax10-G2 display will read [ Z01:Motion Sens ].
6.
Press the
deleted, for example, "Z03:Motion Sens".
7.
Press the
I
OK
The PowerMax10-G2 display will read [ <OFF> to delete ].
8.
Press the
The PowerMax10-G2 display will revert to [MOTION SENSORS].
The device is deleted from the PowerMax10-G2 system.
When exiting "ZONES / DEVICES" menu the PowerMax10-G2 system displays the
number of devices that need to be updated, as follows: DEV UPDATING NNN.
D-302756
or
button repeatedly to select the type of device to be
button.
or
button repeatedly to select the motion sensor to be
button.
button.
ZONE WIRING
Figure 4.1 - Wiring
A
B
2.2kΩ
2.2k Ω
C
ADD NEW DEVICES
DELETE DEVICES
CONTACT SENSORS
MOTION SENSORS
Z01:Motion Sens
Z01:Motion Sens
<OFF> to delete
MOTION SENSORS
I
OK
or
I
OK
or
I
OK
17
Advertisement
Table of Contents
