Table of Contents
Advertisement
[SHOW RF PROBLEMS].
3.
When the PowerMax10-G2 display reads [SHOW RF PROBLEMS], press the
button.
I
OK
The PowerMax10-G2 display switches between the average signal strength
indications for the last 24 hours and between the current signal strength
indications of the first RF device type.∗
4.
Press the
device type.∗
The signal strength indications are as follows: "
"
" (poor communication is detected between the device and the control
BAD COM
panel); "
." (no communication); "
NO COM
any performed test); "
"
" (keyfob 24Hr result); or "
NONE
statistics).
∗
Pressing the
which the signal strength indications refer.
Pressing the
you to "
<OK> TO EXIT
5.1.5 GPRS Communication Test
The GPRS Communication diagnostic procedure tests GSM/GPRS communication and reports the diagnostic result. In
case of communication failure, detailed information of the failure is reported.
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
2.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
The screen will now prompt you to enter your installer code.
3.
Enter your Installer Code.
The PowerMax10-G2 display will read [NEW INSTL CODE].
4.
When the PowerMax10-G2 display reads [NEW INSTL CODE] press the
or
button repeatedly until the PowerMax10-G2 display will read
[DIAGNOSTICS].
5.
When the PowerMax10-G2 display reads [DIAGNOSTICS], press the
button.
The PowerMax10-G2 display will read [WL DEVICES].∗
6.
When the PowerMax10-G2 display reads [WL DEVICES], press the
button.
The PowerMax10-G2 display will read [GSM/GPRS] .
7.
When the PowerMax10-G2 display reads [GSM/GPRS], press the
button.**
The PowerMax10-G2 display will read [PLEASE WAIT...] and will then
8.
automatically change to read [UNIT IS OK].
See the table below for a complete list of possible GSM/GPRS messages.
∗ If there are no wireless devices enrolled in the PowerMax10-G2 system, the
PowerMax10-G2 display reads [
** When the
I
OK
4 min. before it is displayed, depending on the severity of the failure.
Pressing the
64
button to view the signal strength indications for the next RF
NOT TST
" (device is pre-enrolled – not networked);
NOT NET
EARLY
button will display the number and type of device to
I
OK
or
buttons at any stage in the procedure will take
".
NO DEVICES
button is pressed the test result takes between 15 sec. to
or
buttons at any stage in the procedure will take
";
";
STRONG
GOOD
" (results are shown without
" (result of the last 24Hrs without
].
,
;
POOR
BAD
button
.
I
OK
I
OK
I
OK
SHOW RF PROBLEMS
I
OK
Z01: 24hr: GOOD
Z01 NOW: NOT TST
K01: 24hr: NONE
K01: NOW: NONE
READY 00:00
INSTALLER MODE
I
OK
ENTER CODE:
CODE
NEW INSTL CODE
or
DIAGNOSTICS
I
OK
WL DEVICES
GSM/GPRS
I
OK
PLEASE WAIT...
UNIT IS OK
D-302756
Advertisement
Table of Contents
