Table of Contents
Advertisement
7.
Press
and make the selection and then press
I
OK
The PowerMax10-G2 display will revert to [16:NOT READY].
You can now press the
"
" or press the
DEFINE PANEL
4.7.11 Configuring the Time Period by which a Device is considered Missing
Here you determine the time limit for reception of supervision reports from various supervised wireless devices. If any
device does not report at least once within the selected time limit, an "INACTIVITY" alert is initiated.
The options are: 1, 2, 4, 8, 12 hours (default) and disable.
Note: To comply with EN requirements, 1 or 2 hours must be selected.
To Configure the Time Period by which a Device is Considered Missing
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
2.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
The screen will now prompt you to enter your installer code.
3.
Enter your Installer Code.
4.
Press the
option.
5.
When the PowerMax10-G2 display reads [DEFINE PANEL], press
The PowerMax10-G2 display will read [01:ENTRY DELAY 1].
6.
When the PowerMax10-G2 display reads [01:ENTRY DELAY 1], press the
or
[15:SUPERVISION].
7.
Press
and make the selection and then press
I
OK
The PowerMax10-G2 display will revert to [15:SUPERVISION].
You can now press the
"
" or press the
DEFINE PANEL
4.8 Arming/Disarming Options And Exit/Entry Delay
4.8.1 Configuring Exit Modes
Here you determine exit delay mode options. Three types of exit delay modes are available:
restart exit - Exit delay restarts when the door is reopened during exit delay. The restart occurs once only. Restarting the
exit delay is helpful if the user re-enters immediately after going out to retrieve an item that he left behind.
off by door - When the door is closed, the exit delay is automatically terminated (even if the defined exit delay was not
completed).
normal (default) - The exit delay is exactly as defined, regardless of whether the door is open or closed.
To Configure the Exit Modes
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
2.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
The screen will now prompt you to enter your installer code.
44
or
button to take you to "
or
button repeatedly and select the [DEFINE PANEL]
button
repeatedly
or
button to take you to "
to confirm.
I
OK
button to program any other menu in
<OK> TO EXIT
until
the
display
to confirm.
I
OK
button to program any other menu in
<OK> TO EXIT
".
button
.
I
OK
I
OK
will
read
".
button
.
I
OK
I
OK
SELECT OPTION
I
OK
16:NOT READY
READY 00:00
INSTALLER MODE
I
OK
ENTER CODE:
CODE
or
DEFINE PANEL
I
OK
01:ENTRY DELAY 1
or
15:SUPERVISION
I
OK
SELECT OPTION
I
OK
15:SUPERVISION
READY 00:00
INSTALLER MODE
I
OK
D-302756
Advertisement
Table of Contents
