Table of Contents
Advertisement
8.
Press
to confirm.
I
OK
The PowerMax10-G2 display will revert to [AREA CODE].
9.
Press the
The PowerMax10-G2 display will read [LINE PREFIX].
Enter the number that is used as a prefix to access an outside telephone line
10.
(if exists).
11.
Press
to confirm.
I
OK
The PowerMax10-G2 display will revert to [LINE PREFIX].
12.
Press the
The PowerMax10-G2 display will read [DIAL METHOD]. Here you determine
the dialing method used by the automatic dialer built into the PowerMax10-G2
control panel.
13.
When the PowerMax10-G2 display reads [DIAL METHOD], press
The PowerMax10-G2 display will read [ Pulse
14.
Press the
(dtmf)" for example, "tone (dtmf)"
15.
Press
to confirm the selection.
I
OK
The PowerMax10-G2 display will revert to [DIAL METHOD].
16.
Press the
The PowerMax10-G2 display will read [ GSM KEEP ALIVE ]. Here you prevent
the GSM Service provider from disconnecting the GSM line if the user has not
initiated any outgoing telephone calls during the last 28 days.
17.
When the PowerMax10-G2 display reads [ GSM KEEP ALIVE ], press
The PowerMax10-G2 display will read [ disable
18.
Press the
"every 28 days", for example, "every 28 days".
19.
Press
to confirm the selection.
I
OK
The PowerMax10-G2 display will revert to [ GSM KEEP ALIVE ].
You can now press the
press the
4.6.2.2 Configuring GPRS / BB Communicators
The GSM/GPRS module is capable of communicating with the Monitoring station receiver by GPRS, GSM Voice and SMS
Channels. Each of the channels can be separately enabled or disabled in order to allow or prohibit the module from using it
for the event reporting. If all channels are enabled, the GSM/GPRS module will always try GPRS first. If fails, it will try GSM
voice. If fails, it will try any other possible method (PSTN Broadband) and only then it will try SMS. This is due to the fact
that SMS the most unreliable option of communication. Disabling any of the GSM Module channels will cause the module
to use a different sequence than the one described above.
20.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
21.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
22
button.
button.
or
button to select between "Pulse" and "tone
button.
or
button to select between "disable" and
button to revert to the "
button to take you to "
<OK> TO EXIT
.
I
OK
].
.
I
OK
].
" menu, or
AREA CODE
".
button
I
OK
I
AREA CODE
LINE PREFIX
LINE PREFIX
LINE PREFIX
DIAL METHOD
Pulse
tone (dtmf)
tone (dtmf)
DIAL METHOD
GSM KEEP ALIVE
disable
every 28 days
every 28 days
GSM KEEP ALIVE
READY 00:00
.
INSTALLER MODE
OK
I
OK
I
OK
I
OK
or
I
OK
I
OK
or
I
OK
I
OK
D-302756
Advertisement
Table of Contents
