Table of Contents
Advertisement
CHAPTER
3.3.4
Usage examples
This section describes a series of basic operations using the QB-Programmer, using the
example.
The operations from execution of the [Autoprocedure (EPV)] command to programming for the target
device are described.
GUI Operation User's Manual.
The conditions used for a series of operations in this section are as follows.
<Target system>
Target device:
Power supply voltage:
Communication channel:
<MINICUBE2>
Switches:
<QB-Programmer>
Parameter file:
Clock setting:
Operation mode:
Program file:
Command options:
Security function:
44
3
HOW TO USE MINICUBE2 WITH V850 MICROCONTROLLER
For other commands and their applications, refer to the QB-Programmer Programming
μ
PD70F3732
5 V (supplied from MINICUBE2)
CSI-H/S, 2 MHz
Mode select switch: M2
Power select switch: 5
70F3732.PRM
5 MHz, x4 (oscillator on the target system side)
chip
sample.hex
[Blank check before Erase] selected
[Read verify after Program] selected
[Security flag after Program] selected
[Disable Read] selected
User's Manual
U18371EJ5V0UM
μ
PD70F3732 as an
Advertisement
Table of Contents
