Table of Contents
Advertisement
Figure 4-1 and Figure 4-2 present overviews of the MINICUBE2 communication interface.
between MINICUBE2 and the target system, communication circuits must be mounted on the target system, as
shown on the left side of the figure.
<R>
Communication circuits must be
mounted on the target system.
Target device
Target system
Note
To reduce the footprint of the target system, SICA can be used to reduce the size of connectors.
When replacing QB-78K0MINI (obsolete product) with MINICUBE2, a 10-pin connector dedicated to
debugging can be used.
SICA is made by Tokyo Eletech Corporation.
<R>
Communication circuits must be
mounted on the target system.
Target device
Target system
CHAPTER
4
HOW TO USE MINICUBE2 WITH 78K0 MICROCONTROLLER
Refer to this section to design circuits appropriately.
Figure 4-1.
Outline of Communication Interface for On-Chip Debugging
16-pin connector
Communication for
78K0-OCD
debugging
board
Figure 4-2.
Outline of Communication Interface for Flash Programming
16-pin connector
Communication for
programming
Note
USB
communication
MINICUBE2
USB
communication
MINICUBE2
User's Manual
U18371EJ5V0UM
For communication
Host machine
Host machine
53
Advertisement
Table of Contents
