On-Chip Debugging; Debug Functions - Renesas QB-MINI2 User Manual

6.2 On-Chip Debugging

This section describes the system configuration, startup/shutdown procedure and cautions for debugging when
on-chip debugging is performed with MINICUBE2.
6.2.1

Debug functions

Table 6-4 lists the debug functions when a 78K0R microcontroller is the target device and the ID78K0R-QB is
used.
Functions
Target interface
<R>
Security
Download
Execution
Hardware break
Software break
Forced break
<R> Pseudo real-time RAM monitoring
RRM)
<R> DMM (writing to memory during RUN)
Reset masking
Time measurement
(from execution start to break)
User spaces used for debugging
<R>
Note For details, refer to 6.2.5 Securing of user resources and setting of security ID and on-chip debug option
byte.
146
CHAPTER 6 HOW TO USE MINICUBE2 WITH 78K0R MICROCONTROLLER
Table 6-4. Debug Functions
1-wire mode (TOOL0) or 2-wire mode (TOOL0 + TOOL1)
10 byte ID code authentication
Available
Go & Go, Start from Here, Come Here, Restart, step execution
1 point (commonly used by execution and access)
2,000 points
Available
Available
Available
Available (internal/external reset)
Measurement resolution: 100
Max. measurement time: Approximately 100 hours
In 1-wire mode: Internal ROM: 1036 bytes, internal RAM: 6 bytes
In 2-wire mode: Internal ROM: 100 bytes, internal RAM: 6 bytes
User's Manual
Specifications
μ
s
U18371EJ5V0UM
Note
Note