Table of Contents
Advertisement
CHAPTER
5.3 Flash Programming
This section describes the system configuration and startup/shutdown procedure when flash programming is
performed for a 78K0S microcontroller, using MINICUBE2.
5.3.1
Specifications of programming function
Functions
Host interface
Target interface
Target system voltage
Clock supply
Power supply
Acquisition of device-specific
information
Security flag setting
Standalone operation
5.3.2
System configuration
Figure 5-17 illustrates the system configuration for flash programming.
<5>
<5>
<6>
<6>
Target system
Target system
<1> Host machine
Products with USB ports
<2> Software
Includes the QB-Programmer USB driver, parameter files, and so on.
Download these NEC Electronics software from the following website (ODS).
URL: http://www.necel.com/micro/ods/eng/
<3> USB cable (accessory)
<4> MINICUBE2 (this product)
<5> 16-pin target cable (accessory)
<6> Target connector (sold separately)
128
5
HOW TO USE MINICUBE2 WITH 78K0S MICROCONTROLLER
Table 5-5. Specifications of Programming Function
USB 2.0 (compatible with 1.1)
UART
2.7 to 5.5 V (depends on the target device)
8 MHz clock can be supplied
3 or 5 V (maximum current rating: 100 mA)
Parameter file for NEC Electronics PG-FP4 is used
Available
Unavailable (must be connected to host machine)
Figure 5-17. System Configuration for Flash Programming
<4>
<4>
User's Manual
Specifications
<3>
<3>
U18371EJ5V0UM
<1>
<1>
<2>
<2>
Advertisement
Table of Contents
