Table of Contents
Advertisement
(4) Connecting the target system
Connect MINICUBE2 to the target system as shown in Figure 4-25. Select a 10- or 16-pin target cable
according to the target system circuit (refer to Remark below).
Perform connection before the power to the target system is turned on
Target system
Target system
Caution On-chip debugging using TOOLCx and TOOLDx can be performed without using the
<R>
Remark
Connect the 78K0-OCD board and the 10-/16-pin target cable as shown below. Do not connect both
the 10-pin target cable and 16-pin target cable.
With 10-pin cable: Connect CN2 on the 78K0-OCD board to the 10-pin target cable (Figure 4-26).
With 16-pin cable: Connect CN3 on the 78K0-OCD board to the 16-pin target cable (Figure 4-27).
Figure 4-26. With 10-Pin Connector
Caution Connect the 78K0-OCD board to the target cable so that pin 1 position (▲) on each side
78
CHAPTER
4
HOW TO USE MINICUBE2 WITH 78K0 MICROCONTROLLER
Figure 4-25. Connecting MINICUBE2 to Target System
10-/16-pin target cable
10-/16-pin target cable
78K0-OCD board.
When TOOLC0 and TOOLD0 are used, a 4, 8, or 16 MHz clock signal generated by MINICUBE2
can be used for the clock signal of the microcontroller.
match.
User's Manual
78K0-OCD
78K0-OCD
board
board
Figure 4-27. With 16-Pin Connector
U18371EJ5V0UM
MINICUBE2
MINICUBE2
Advertisement
Table of Contents
