Renesas QB-MINI2 User Manual page 96

(11)Caution on mounting a clock on 78K0-OCD board
When a clock is mounted on the 78K0-OCD board, power supply may not become the GND level even if the
power to the target system is shut down.
(12) Emulation of POC function
If power supply to the target system is turned off during debugging, the target device enters the reset state by
the RESET_OUT pin of MINICUBE2.
emulation. Note that there is an error of ±1 V between the POC detection voltage and the target system
voltage. Note that the POC detection voltage might be 1 V higher than that of the target device.
<R>
(13) Device with/without on-chip debug function
Only the devices with the on-chip debug function can be debugged. See the user's manual of the target device
for checking whether it is equipped with the on-chip debug function.
To debug a device without the on-chip debug function, perform debugging by using an upper-compatible
product. The following shows an example when using the 78K0/KF2.
Target Device
μ
PD78F0544
μ
PD78F0545
μ
PD78F0546
μ
PD78F0547
94
CHAPTER 4 HOW TO USE MINICUBE2 WITH 78K0 MICROCONTROLLER
Consequently, the target device's POC function performs pseudo
On-Chip Debug Function
Not equipped
User's Manual
Device for Debugging
μ
PD78F0547D
(Set the IMS and IXS registers to
values according to the target device.)
U18371EJ5V0UM
Device File (DF)
Used for Debugging
μ
DF for PD78F0544
μ
DF for PD78F0545
μ
DF for PD78F0546
μ
DF for PD78F0547