Edition
2nd
Change of Figure 4-2 in 4.1 Target System Design
edition
4.1.2 Circuit connection examples
•
Addition of Note 2 in Table 4-5
•
Addition of Note 7 in Figure 4-3 and 4-4
•
Addition of Note 6 in Figure 4-5 to 4-9
• Addition of Note 5 in Figure 4-10 and 4-11
Change of 4.1.3 (4) Resetting the target device by power-on clear (POC) only
Description added to 4.2.6 Securing of user resources and setting of security ID
4.2.7 Cautions on debugging
• Change of (13) Emulation of POC function
• Addition of (14) Device with/without on-chip debug function
Note 2 of Figures 5-2 in 5.1.2 Circuit connection example corrected, Note 6 added
Description added to 5.2.5 Securing of user resources
Change of Table 6-1 in 6.1 Target System Design
Note 2 of Figures 6-2 in 6.1.2 Circuit connection example corrected, Note 5 added
6.2.5 Securing of user resources and setting of security ID and on-chip debug
option byte
•
Description of material added
•
Addition of Note 1 in Figure 6-11
•
Addition of Note in (a) Securement of debug monitor area
6.2.6 Cautions on debugging
•
Deletion of (5) Step execution
•
Change of (7) LVI default start function setting (address C1H)
•
Change of (10) Operation at voltage with which flash memory cannot be written
•
Change of (11) Debugging in 1-wire mode
•
Change of (12) Pseudo real-time monitor function
Addition of APPENDIX A EQUIVALENT CIRCUIT
176
APPENDIX B REVISION HISTORY
Description
User's Manual U18371EJ5V0UM
(3/3)
Applied to
CHAPTER 4 HOW TO
USE MINICUBE2 WITH
78K0
MICROCONTROLLER
CHAPTER 5 HOW TO
USE MINICUBE2 WITH
78K0S
MICROCONTROLLER
CHAPTER 6 HOW TO
USE MINICUBE2 WITH
78K0R
MICROCONTROLLER
APPENDIX A
EQUIVALENT CIRCUIT