Renesas QB-MINI2 User Manual page 17

(3) USB interface connector
This is a connector used to connect MINICUBE2 with the host machine, via a USB cable.
A USB 2.0 compliant mini-B connector (UX60A-MB-5ST: Made by Hirose Electric Co., Ltd.) is employed.
(4) Target interface connector
This is a connector used to connect MINICUBE2 with the target system, via a 16-pin target cable. Connect
the 78K0-OCD board for debugging a 78K0 microcontroller. To prevent the 78K0-OCD board from being
inserted by mistake, pin 11 is removed at shipment.
Since this connector is compatible with 16-core 2.54 mm pitch general-purpose connectors (female), a
commercially available cable can be substituted.
(5) Mode LED
The appearance of the mode LED changes according to the status of hardware and software, as shown in
Table 2-3.
Mode LED Appearance
Color
- Extinguished
White
Flashing
Glowing
Blue
Glowing
Flashing
Orange
Glowing
Flashing
Green
Glowing
Flashing
Yellow
Glowing
Flashing
Red Glowing
Illumination
CHAPTER 2 NAMES AND FUNCTIONS OF HARDWARE
Table 2-3. Mode LED Status
USB Target VDD
Connection Detection
Not Not detected
connected
Connected Not detected
Detected
The illumination mode is entered when MINICUBE2 is connected to a USB interface and 15
seconds or longer have elapsed. This mode is also entered when the debugger is terminated
normally.
User's Manual
Description
Software Operation Status
Not yet started
Not yet started
Not yet started
A debugger for V850 microcontrollers has been started and
CPU is in the break mode.
A debugger for V850 microcontrollers has been started and
the CPU is running, or a program is being downloaded.
A debugger for 78K0 microcontrollers has been started and
the CPU is in the break mode.
A debugger for 78K0 microcontrollers has been started and
the CPU is running, or a program is being downloaded.
A debugger for 78K0S microcontrollers has been started and
the CPU is in the break mode. The QB-Programmer has
been started and is waiting for execution processing.
Alternatively, execution processing has been completed.
A debugger for 78K0S microcontrollers has been started and
the CPU is running, or a program is being downloaded.
A debugger for 78K0R microcontrollers has been started and
the CPU is in the break mode.
A debugger for 78K0R microcontrollers has been started and
the CPU is running, or a program is being downloaded.
A command from the QB-Programmer is being executed for
the flash memory.
A command from the QB-Programmer is ended abnormally
(results in error)
U18371EJ5V0UM
15