Table of Contents
Advertisement
8.2 Firmware Update Procedure
(1) Preparation and installation of software
The following software is required to update firmware. For details on preparation and installation of software,
refer to the setup manual supplied with MINICUBE2.
• MINICUBE2 diagnostic tool
• USB driver
(2) Switch setting
The mode select switch and power select switch may be set to any position.
(3) Connecting the USB cable
Connect MINICUBE2 to the host machine. Do not connect MINICUBE2 to the target system. The mode
LED glows white after connection.
MINICUBE2
MINICUBE2
(4) Startup of MINICUBE2 diagnostic tool
Start the MINICUBE2 diagnostic tool.
If the MINICUBE2 diagnostic tool was installed when NEC Electronics software was installed, the diagnostic
tool is registered on the Start menu as follows.
"NEC Electronics"→"MINICUBE Utilities"→"Vx.xx (version)"
•
For the operation after this step, refer to the user's manual for the MINICUBE2 diagnostic tool.
172
CHAPTER
8
Figure 8-2. Connecting MINICUBE2 to Host Machine
USB cable
USB cable
User's Manual
FIRMWARE UPDATE
U18371EJ5V0UM
Host machine
Host machine
Advertisement
Table of Contents
