Table of Contents
Advertisement
Revisions up to the previous edition are shown below. The "Applied to" column indicates the chapter in each
edition to which the revision was applied.
Edition
<R>
5th
Change of Figure 3-2. Recommended Circuit Connection When UART Is Used for
edition
Communication Interface
Change of Figure 3-3. Recommended Circuit Connection When CSI-H/S Is Used for
Communication Interface
Addition of Caution
Change of 4.1 Target System Design
Addition of Note in Figure 4-1. Outline of Communication Interface for On-Chip
Debugging
Change of Note in Figure 4-2. Outline of Communication Interface for Flash
Programming
Change of Table 4-1. Pin Assignment When Using 16-Pin Target Cable
Change of Table 4-2. Pin Functions
Change of Table 4-3. Pin Assignment When Using 10-Pin Target Cable
Change of Table 4-4. Pin Functions
Change of Table 4-5. Corresponding Circuit Connection Diagrams
Addition of Figure 4-3. Flow Chart for Selecting the Circuit
Change of Figure 4-12. When Only Debugging Is Performed (with OCD1A/OCD1B
communication) to Figure 4-4. When Both Debugging and Programming Are
Performed (Not communicating by using the OCD0A and OCD0B pins or not using
the X1 oscillator)
Addition of Caution in 4.1.3 Connection of reset pin
Addition of Figure 4-14. Cautions for using the RESET-OUT pin
Change of 4.1.3 (2) Automatically switching the reset signal via selector logic
Change of Description in 4.1.3 (4) Resetting the target device by power-on clear
(POC) only
Change of Description in 4.1.4 Cautions on target system design
Change of Table 4-6. Debug Functions
Addition of Note in Figure 4-24. System Configuration for On-Chip Debugging
Addition of Caution in Figure 4-25. Connecting MINICUBE2 to Target System
Change of 4.2.5 Clock setting
Change of Figure 4-32. Reserved Area Used by MINICUBE2
Change of 4.2.6 (a) Debug monitor area (this area must be secured)
Change of Table 4-8. Option Byte (84H) Settings and Descriptions
Addition of Table 4-9. Option Byte (84H) Settings and Descriptions
Change of 4.2.6 (d) Stack area for debugging (this area must be secured)
Change of Description in 4.2.6 (f) Pseudo real-time RAM monitor (RRM) area
Change of Description in 4.2.7 (2) Overwriting flash memory during on-chip
debugging
Change of Caution in 4.2.7 (9) Cautions when stepping into code
174
APPENDIX B REVISION HISTORY
Description
User's Manual U18371EJ5V0UM
(1/3)
Applied to
CHAPTER 3 HOW TO
USE MINICUBE2
WITH V850
MICROCONTROLLER
CHAPTER 4 HOW TO
USE MINICUBE2
WITH 78K0
MICROCONTROLLER
Advertisement
Table of Contents
