Scanning Modes - Wasp WLS9600 Quick Reference Manual

Scanning Modes

Scanning Modes
The reader can operate in one of several scanning modes:
Trigger Single — When the trigger is pulled, scanning is activated
until one of the following occurs:
- a programmable duration
- a label has been read
- the trigger is released
This mode is associated with typical handheld reader operation:
when the trigger is pulled, scanning starts and the product scans
until the trigger is released, or a label is read, or the maximum pro-
grammable duration
Trigger Hold Multiple — When the trigger is pulled, scanning
starts and the product scans until the trigger is released or a pro-
grammable duration
scanning. Double Read Timeout
reads while in this mode.
Trigger Pulse Multiple — When the trigger is pulled and released,
scanning is activated until programmable duration
the trigger has been pulled again to transition to another state.
Double Read Timeout
this mode.
Flashing — The reader flashes
status.
Always On — No trigger pull is required to read a barcode. Scan-
ning is continually on
Stand Mode — No trigger pull is required to read a barcode. Scan-
ning is alternatively turned on and off.
1. See the Product Reference Guide (PRG) for additional programmable fea-
tures, in this case: Scanning Active Time.
2. Double Read Timeout is also programmed using the PRG.
3. Controlled by Flash On Time and Flash Off Time. Use the PRG to program
these options.
4. For energy saving purposes, the Always On feature has a user program-
mable timeout (default 5 hours of inactivity). A single manual trigger
pull is required to reactivate the scanner after the timeout.
8
1
has elapsed.
1
has elapsed. Reading a label does not disable
2
2
prevents undesired multiple reads while in
3
on and off regardless of the trigger
4
.
1
has elapsed
prevents undesired multiple
1
has elapsed or
WLS9600