Set Scanner 1D - Wasp WWS150i User Manual

Chapter 4
Set Scanner ID
Setting the scanner ID allows you to give each scanner a unique name. This unique name identifies it if you have more than one scanner in the
area.
Set Scanner ID procedure:
1. Clear Scanner ID
2. Set Scanner ID
3. Scan up to 16 characters from the ASCII table on pp 28-31.
4. Set Scanner ID
5. Bluetooth HID
Note: Sometimes only 8 characters of a longer name are seen when pairing, e.g. "Wasp Bar" instead of "Wasp Barcode".
Clear Scanner ID procedure:
1. Clear Scanner ID
2. Bluetooth HID
Note: WWS150i & WWS550i: name defaults to "Wasp Barcode".
For the scanner to transmit a new name, it may need to be unpaired. When the new name is seen, set the power-off time back to a longer value.
SET SCANNER ID
Step 1 - Default Wireless ID
Step 2 - Set Wireless ID
Step 3 - Scan up to 16 alphanumeric
characters from Full ASCII Table as your
desired ID name.
Step 4 - Set Wireless ID
15
*Default