Edid Mode - Lightware MX-FR9 User Manual

5.4.4. EDID mode

To enter or to exit from this mode press and release the EDID button. EDID mode is
active when the EDID button is illuminated on the front panel. All EDIDs are referred with
their memory location e.g. F49 or D03, see section 5.3 about EDID memory structure on
page 44.
Select menu items with up ▲ and down ▼ buttons and
then press enter  or right ► button to step in
submenus. Press the escape ● button to return to main
EDID management menu.
Info: You can cancel any not yet executed operation by exiting the EDID menu.
Info: Source and destination buttons are disabled while EDID mode is active.
View EDID menu
All the stored EDIDs can be checked through this menu.
The EDID types are grouped in submenus.
The most important information about each EDID is
shown in the submenu.
Use the left ◄ and right ► buttons to select the desired
EDID. The monitor name and the preferred resolution can
be checked.
Save EDID menu
The EDID from any connected monitor can be learned to
user memory slots. Select the dynamic EDID of the output
port with the left ◄ and right ► buttons. Then press
down ▼ and select the user EDID slot where the
monitor's EDID has to be stored.
After the desired dynamic EDID and user memory is
selected, go to 'Save!' and press the enter  or right ►
button to store the EDID.
Switch EDID menu
The emulated EDIDs can be changed in this menu.
Dynamic, User or Factory EDIDs can be selected in the
top row with the left ◄ and right ► buttons. The preferred
resolution of the selected EDID is shown in the second
row of the screen.
Press down ▼ and then select the input port with the left
◄ and right ► buttons.
After the desired EDID and input port is selected, go to
'Do switch!' and press enter  or right ► button to
change the emulated EDID.
The 'Operation is progress' message appears on the LCD. If switching the EDID succeed
then 'Operation done!' message is shown for 2 seconds.
Page 58 / 137
EDID management
~View EDID
Save EDID
Switch EDID
View EDID
~Dynamic EDIDs
Emulated EDIDs
Factory EDIDs
Dynamic EDIDs
<EDID mem: D15
PHL Philips 230W5
1920x1200@59.94Hz
EDID save
<Dynamic EDID D6
to User EDID U2
Save!
EDID save
Dynamic EDID D6
to User EDID U2
~Save!
<Switch EDID: F21
LWR D1600x1200p60
to input: 4
Do switch!
Switch EDID: F21
LWR D1600x1200p60
to input: 4
~Do switch!
Section 5. Operation
>>
>>
>
>
>>
>
>>