Table of Contents
Advertisement
6.3.7. Preset names
To help memorizing the preset configurations, names can be assigned to saved presets.
Preset names can be maximum 15 characters long, and can contain any ASCII
characters except: ( ) { }.
Rename preset
Step 1. Select the preset memory (Preset1...Preset32) you want to rename.
Step 2. Click RENAME... in the popup menu. The Rename window appears.
Step 3. Type in the desired name and click APPLY. Now the new preset name is stored.
Read preset names
The control software downloads the names automatically upon establishing connection to
the matrix. Preset names can be re-read manually by clicking on the READ PRESET
NAMES button in the preset area.
6.3.8. Input parameter settings
By clicking on an input label a dialog window appears showing the parameters for the
corresponding input. Some settings are only accessible with certain input boards. The
exact look of the setting window may depend on the type of the board because the
different boards have different capabilities.
Scope of changes
There are two options to apply changes. To set
the scope of the changed settings, select the
desired option in the top left box.
Apply changes to current input:
applied only to the currently selected port.
Apply changes to all inputs: this option means that the modified parameters are applied
to all input ports which are the same type as the currently viewed port.
Info: When opening this window again, the scope selection will be set to "Current Input"
regardless of the active selection at the time of closing. It is to avoid making changes to
all inputs by mistake.
Reload factory defaults
Factory default parameters can be reloaded for
the current port or all ports of this type by clicking
these buttons.
Current input: Reloads the default values to the currently selected input.
All inputs: Loads the factory default values to all inputs which are the same type as the
currently viewed input port.
Section 6. Software control – Using Lightware Matrix Controller
MX-FR series modular matrices
this option means the modified parameters are
User's Manual
Page 71 / 137
Advertisement
Table of Contents
