Lightware MX-FR9 User Manual page 78

Output format
This sets the signal type to DVI or HDMI mode which is sent towards the matrix
crosspoint.
Pass HDMI: Send HDMI signal to the crosspoint only if the incoming signal is HDMI or
Force DVI: Send only DVI signal to the crosspoint without embedded audio.
Automatic: Detect the output board types in the matrix frame and sets the signal type
HDCP enable
The HDCP capability can be enabled or disabled on the input port. This can prevent
unnecessary HDCP encryption with certain source devices. Note that only unprotected
contents can be played on the source if this setting is disabled (unchecked). See section
4.4 on page 36 for more information.
No sync color
The port generates a solid 640x480 resolution image when there is no incoming signal.
The color of this picture can be set here.
Status
Basic status of the port is shown here.
Signal:
HDCP:
DVI 5V:
Sync type:
Video signal info
Resolution, color depth and color space of the incoming signal is shown.
The 'Timing type' and 'Timing ID' fields are used only when an analog video signal is
detected and show which parameters are used to digitize the incoming analog signal. The
input port measures the incoming analog signal and determines timings. If the parameters
need adjustment, it can be done on the right side at 'analog options'. In this case the
'Timing ID' field changes to 'user modified' till the parameters are not saved.
Audio signal info
Information about the incoming embedded audio signal is shown. This audio could be
replaced with audio from the add-on in the signal which is sent towards the crosspoint.
The shown information represents always the incoming embedded audio, not the
forwarded signal.
Audio settings
The below settings appear only with the MXD-UMX-IB.
Audio source
The signal which is sent to the matrix crosspoint can have embedded audio.
No audio embedding:
Page 78 / 137
the audio settings are set to embed audio.
accordingly. If there are only HDMI compatible output boards then the signal
type will be HDMI. If there is one or more DVI output boards in the matrix
frame then the signal type will be DVI. (Note that DVI-HDCP boards are
HDMI compliant)
Shows if there is a valid video signal present on the input port. The signal
mode is detected and shown including DVI or HDMI mode and color
depth. HDCP encryption.
Shows if the incoming signal is encrypted or not.
Shows if there is a source device connected to the input port.
Shows if the incoming analog video has separate or composite HV sync
signals. For digital signals 'digital' appears.
Disables audio in the signal.
Section 6. Software control – Using Lightware Matrix Controller