Table of Contents
Advertisement
Enable Dual Link: The dual-link channel is enabled disregarding the input port type.
Disable Dual Link: The dual-link channel is disabled. In this case no dual-link signals can
Auto Mode:
6.3.9.4. Output parameter settings for 'HDMI' type boards
Covered boards: MX-HDMI-OB, MX-DVI-HDCP-OB, MX-HDMI-TP-OB,
Output Mode
The signal mode can be set to DVI, HDMI 24bit, HDMI 30bit, HDMI 36bit or Auto mode.
The 'Auto' option sets the signal mode regarding to the attached display device's EDID
and the incoming signal.
Color space
Can be set to RGB, YUV444, YUV422 or Auto. Convert the color space on the output to
the given type. Please note that DVI signals support only RGB color space.
Page 84 / 137
Some dual-link monitors may display distorted, squeezed picture
when the signal comes from a single-link input port.
be used. Use this setting if a single-link signal has to be routed to the
output and the Auto mode does not work.
Enables or disables the dual-link channel depending on the input port
type. If the input port is single-link then the dual-link channel is
disabled. If the input port is dual-link then the dual-link channel is
enabled. Note that only the port type depends not the signal type on
the port.
MXD-HDMI-TP-OB, MX-CPU2 Preview Output
Figure 6-11. Output parameters for HDMI boards
Section 6. Software control – Using Lightware Matrix Controller
Advertisement
Table of Contents
