Table of Contents
Advertisement
6.3.9.5. Output parameter settings for 'HDMI-OPT' type boards
Covered boards: MX-HDMI-OPT-OB-...
Optical module parameters
The optical module's type and serial number is shown. The connector type is the
standard name of the fiber connector which is mounted on the back plate of the board.
The connector type can be: LC, SC, ST, and NT (Neutrik OpticalCON).
Laser enable
The optical module can be powered down with this setting. This can help to prevent aging
of the laser transmitter and save lifetime. If the laser is disabled then no signal
transmission is available.
Serial port extension parameters
MX-HDMI-OPT boards provide bidirectional RS-232 communication with periphery
devices at remote endpoints through optical extenders. This communication is transmitted
over the same fiber cable as the video signal.
Serial passthru: The remote serial communication feature can be enabled or disabled.
Serial link:
Baudrate:
Periphery device: Set if the periphery device connected to the remote extender needs
Page 86 / 137
It is recommended to disable this feature if not used.
Shows if there is a compatible receiver connected.
The baudrate can be set. The receiver unit (HDMI-OPT-RX) will
communicate with this baudrate with the periphery device.
ASCII or Binary control commands. It set to disabled then the
periphery device could not send commands back.
Section 6. Software control – Using Lightware Matrix Controller
Advertisement
Table of Contents
