Lightware MX-FR9 User Manual page 19

Status LEDs
1
2 DIP settings
3 Alarm out
4 Genlock
5
Preview output
Test input
7
Serial port
6
Ethernet port
8
9
CPU live
10 Reset button
11
Input boards
12 Power supplies
Output boards
13
Section 3. Controls and connections
LED indicators for internal DC power voltages, and alarm.
Special settings can
Standard SMPTE 269M alarm output with BNC connector. See
section 3.7.8 for more information.
LED indicators for genlock status, and BNC receptacles for
genlock loop connection. See section 3.7.7 for
information.
DVI output connector, which is directly connected to the 80
output. See section 2.1.1 for more information.
DVI input connector, which can be configured as an alternative
th
for the 80 input. See section 2.1.1 for more information.
9 pole D-SUB female connector. Can be ordered with RS-232
or RS-422 control. See section 3.7.5 for more information.
Locking RJ45 connector. Remote control port for connecting the
unit to Local Area Network (LAN). See section 3.7.6 for more
information.
CPU live LED blinks
Reset button reboots the matrix. This is same as disconnecting
from power source, and reconnect again.
Modular input board slots. Connect DVI source devices to these
connectors.
Hot swap slots for power supply units. See section 5.1 for more
information.
Modular output board slots. Connect DVI sink devices to these
connectors.
MX-FR series modular matrices
User's Manual
be made with these
to indicate normal
switches.
more
th
operation.
Page 19 / 137