Front Panel Lcd Menu Operation; Basic Concept - Lightware MX-FR9 User Manual

5.4. Front panel LCD menu operation

5.4.1. Basic concept

There are three operating modes of the LCD menu:
Normal mode
EDID mode
Signal present mode
Menu structure
Normal mode
Page 46 / 137
Most settings can be done in this mode. It is active when none
of the EDID or the SIGNAL PRESENT button lights.
Use this mode to set up the emulated EDID on the inputs, learn
EDID form the outputs or to view the EDID memory. Enter or
exit this mode by pressing the EDID button. The illuminated
EDID button shows that this mode is active.
This mode is for checking the presence of incoming signals and
display devices. Enter or exit this mode by pressing the SIGNAL
PRESENT button. The illuminated SIGNAL PRESENT button
shows that this mode is active.
IP settings
IP status
DHCP enable [-]
Port
IP address
IP gateway
IP subnet
Save & exit
RS-232 settings
Baud rate
Protocol settings
LAN
RS-232
Input settings
Output settings
Hardware status
Router status
Card information
Firmware versions
Factory reset
IP reset
I/O card reset
EDID reset
HDCP key reset
Protocol reset
All reset
HDCP keycounter
View log...
Switch In## Out## / Input #80
EDID mode
View EDID
Dynamic EDIDs
Emulated EDIDs
Factory EDIDs
User EDIDs
Save EDID
Switch EDID
Signal present mode
Test input
Preview output
Genlock state
Crosspoint
Crosspoint status
Section 5. Operation