Table of Contents
Advertisement
Scope of changes
There are two options to apply changes. To set
the scope of the changed settings, select the
desired option in the top left box.
Apply changes to current output: this option means the modified parameters are
applied only to the currently selected port.
Apply changes to all outputs: this option means that the modified parameters are
applied to all output ports which are the same type as the currently viewed port.
Info: When opening this window again, the scope selection will be set to "Current Output"
regardless of the active selection at the time of closing. It is to avoid making changes to
all outputs by mistake.
Reload factory defaults
Factory default parameters can be reloaded for
the current port or all ports of this type by clicking
these buttons.
Current output: Reloads the default values to the currently selected output.
All outputs: Loads the factory default values to all outputs which are the same type as
the currently viewed output port.
6.3.9.1. Output parameter settings for 'DVI-D' type boards
Covered boards: MX-DVID-OB, MX-DVI-TP-OB, MX-DVI-TP-OB+,
Parameters
The factory default settings give good result in most cases. Please consult Lightware
support for further information if encountering problems with output signals.
Page 82 / 137
MX-DVI-OPT-OB-R-...
Figure 6-9. Output parameters for DVI-D boards
Section 6. Software control – Using Lightware Matrix Controller
Advertisement
Table of Contents
