Table of Contents
Advertisement
8.5.7. Change control protocol
Description: Matrix routers can be controlled with different control protocols. This
command sets the active protocol only for the currently used control interface.
Info: The setting applies only for the interface that was used to send the command!
Info: The USB interface always uses the Lightware protocol, this cannot be changed.
Command {P_<protocol>}
Response (PROTOCOL●#<protocol>●
Explanation: The matrix communicates with Lightware protocol.
Possible settings:
Info: Be aware that different control interfaces can be set to use different protocols. E.g. the
Ethernet interface can use the Lightware protocol while the Serial interface uses
Protocol#2 at the same time.
Info: Control protocol for each interface can be checked by the front panel buttons (section
Error! Reference source not found.) or on the front panel LCD menu as well.
8.5.8. Configure remote alerts
Description: The matrix logs different levels of errors. Configure which level of errors has
to be sent out as an alarm message.
Command
Response (ELEVELSEND#<p>=
Explanation: The matrix will send an immediate message on all control interfaces when
a 'matter', 'error' or 'fatal' level error occurs.
Legend: <p>: Adjusted control interface
See section 8.6.10 for more information about error levels.
Section 8. Programmer's reference
Format
SELECTED!)CrLf
<protocol>
Control protocol
1
Lightware
2
Protocol #2
3
LW simple
Format
{ELEVELSEND#<p>=
<0>;<1>;<2>;<3>;<4>}
<0>;<1>;<2>;<3>;<4>)CrLf
<0>: 'Notice' level events
<1>: 'Warning' level events
<2>: 'Matter' level events
<3>: 'Error' level events
<4>: 'Fatal' level events
MX-FR series modular matrices
Example
→ {P_1}
← (PROTOCOL #1 SELECTED!)CrLf
(default)
(not for use)
Example
→ {ELEVELSEND#0=0;0;1;1;1}
← (ELEVELSEND#0=0;0;1;1;1)CrLf
0 = all
1 = RS-232
2 = LAN
3 = USB
0 = no immediate message send
1 = immediate message
0 = no immediate message send
1 = immediate message
0 = no immediate message send
1 = immediate message
0 = no immediate message send
1 = immediate message
0 = no immediate message send
1 = immediate message
User's Manual
Page 113 / 137
Advertisement
Table of Contents
