Table of Contents
Advertisement
6.3.8.7. Input parameter settings for '3G-SDI' type boards
Covered boards: MX-3GSDI-IB
Setting for input port
Output mode
This sets the signal type to DVI or HDMI mode which is sent towards the matrix
crosspoint.
Audio dependent: Send HDMI signal to the crosspoint if the audio source is set to
Force HDMI:
Force DVI:
Frame compatible: Detect the output board types in the matrix frame and sets the signal
Audio source
The audio source which is embedded to the forwarded HDMI signal can be set.
SDI:
S/PDIF:
No audio: The forwarded signal will not have any embedded audio.
Page 80 / 137
embed audio from SDI or S/PDIF.
Always send HDMI signal to the crosspoint. If there is no incoming
audio on the selected audio source then silence is embedded into
the forwarded signal.
Send only DVI signal to the crosspoint without embedded audio.
type accordingly. If there are only HDMI compatible output boards
then the signal type will be HDMI. If there are one or more DVI
output boards in the matrix frame then the signal type will be DVI.
(Note that DVI-HDCP boards are HDMI compliant)
The forwarded signal will have the embedded audio from the SDI input.
The forwarded signal will have the audio from the S/PDIF input.
Section 6. Software control – Using Lightware Matrix Controller
Advertisement
Table of Contents
