Switching And Control Commands; Mx-Cpu2 Test Input And Preview Output; Select 80 Th Input Port; Switch One Input To One Output - Lightware MX-FR9 User Manual

Hide thumbs Also See for MX-FR9:
Table of Contents

Advertisement

8.4. Switching and control commands

8.4.1. MX-CPU2 Test input and Preview output

MX-FR80R and MX-FR80R
Used in the MX-FR80R or MX-FR65R router frame, the Preview output is directly
connected to the 80
the same signal as the 80
The 80
port of the 10
selected port (Test input or Input board #10) will be available as the 80
crosspoint switch.
Other frames
All other frames use the Test input and Preview output just like any other ports. These
ports are referred as the last port in the crosspoint.
8.4.2. Select 80
Info: Available only for MX-FR80R and MX-FR65R.
Description: Configure the crosspoint's 80
of the 10
Command {TI=<value>}
Response (TI=<value>)CrLf
Explanation: Query Test input state. Test input is selected for the 80
crosspoint. The last port on the 10
Legend: <value>: ? = Query 80
Info: The status of the multiplexer is not shown in other crosspoint commands. The crosspoint
switching works independent from this setting.

8.4.3. Switch one input to one output

Description: Switch input <in> to output <out>.
Command {<in>@<out>}
Response (O<out²>●I<in²>)CrLf
Explanation 1: Input 1 is switched to output 5.
Section 8. Programmer's reference
th
output port with a DVI splitter. Therefore this port always outputs
th
output, even if it has a different interface (TP, OPT, etc.).
th
input port of the crosspoint is multiplexed between the Test input port and the 8
th
input card. This switch is independent from the crosspoint state. The
Frame
Test input
MX-FR9
MX-FR17
in 17
MX-FR33
in 33
MX-FR33R
in 33
MX-FR65R
in 80
multiplexed
MX-FR80R
in 80
th
input port
th
input card.
Format
0 = Set port multiplexer to use the 8
1 = Set port multiplexer to use the Test input port.
Format
Preview output
in 9
out 9
out 17
out 33
out 33
out 80
distributed
out 80
th
port to use the Test input port or the 8
Example (MX-FR80R)
→ {TI=?}
← (TI=1)CrLf
th
input board is not used.
th
port multiplexer status.
→ {1@5}
← (O05 I01)CrLf
MX-FR series modular matrices
User's Manual
th
input on the
th
th
port of the 10
input card.
Example 1
Page 103 / 137
th
th
port
th
input of

Advertisement

Table of Contents
loading

Table of Contents