Lightware MX-FR9 User Manual page 52

Output port settings submenu (HDMI type)
Covered
MX-CPU2 Preview output
The 'Signal mode' can be set to DVI, HDMI 24bit, HDMI
30bit, HDMI 36bit or Auto mode. The 'Auto' option sets
the signal mode regarding to the attached display
device's EDID and the incoming signal. Use the left ◄
and right ► buttons to change the value.
The 'Colorspace' can be set to RGB, YUV444, YUV422
or Auto. Convert the color space on the output to the
given type. Please note that DVI signals support only
RGB color space. Use the left ◄ and right ► buttons to
change the value.
The 'Colorrange' can be set to compress, expand or
Auto. Use the left ◄ and right ► buttons to change the
value.
With the 'PCM subsample' setting the 2-channel PCM
audio can be subsampled by 2x or 4x. The minimum of
the new sampling frequency is 44.1kHz. Use the left ◄
and right ► buttons to change the value.
The 'Encryption' option sets the HDCP encryption on the
output. The Auto setting applies encryption when the
incoming signal is encrypted. The Always setting forces
encryption on any incoming video signal. Use the left ◄
and right ► buttons to change the value.
Output port settings submenu (DVIDL type)
Covered boards: MX-DVIDL-OB
The 'DualLink mode' can be set to enable or disable the
wires needed for Dual-Link signals. The disable mode
virtually disconnects the Dual-Link TMDS wires. The Auto
mode considers the actual connected input port type. Use
the left ◄ and right ► buttons to change the value.
Output port settings submenu (OPT type)
Covered boards: MX-DVI-OPT-OB(-RCLK), MX-HDMI-OPT-OB
The laser on each output port can be enabled or disabled.
Disabling unused laser outputs can lengthen their
lifespan. Use the left ◄ and right ► buttons to change
the value.
The MX-DVI-OPT-OB-RCLK board has additional settings
as described for DVI-D type output boards.
Hardware status menu
Navigate to this menu in the main menu list and press
enter  or right ► button.
The monitored voltage levels, fan speeds, etc. can be
scrolled through with up ▲ and down ▼ buttons.
Press the escape ● button to return to main menu.
Page 52 / 137
boards: MX-HDMI-OB, MX-DVI-HDCP-OB,
Output 9 settings
~Signal mode
~< HDMI 24 bit
Colorspace
Output 9 settings
~Colorspace
~< RGB
Color range
Output 9 settings
~Colorrange
~< Expand
PCM subsample
Output 9 settings
~PCM subsample
~< 2x
Encryption
Output 9 settings
2x
~Encryption
~< Auto
Output 4 settings
~DualLink mode
~< Enable
Output 15 settings
~Laser enable
~< On
~Hardware status
Hardware status
CPU 3.3V:
CPU 5V:
Battery:
Section 5. Operation
MX-HDMI-TP-OB,
~
>~
~
>~
~
>~
~
>~
~
>~
~
>~
~
>~
>>
3.32V
5.03V
2.60V