Table of Contents
Advertisement
8.4.10. Unmute specified output
Description: Unmute output <out>.
Command {+<out>}
Response (0MT<out²>)CrLf
Explanation: Output 3 is unmuted. Now output 3 is switched to the input it was
connected to prior to the mute command.
Info: Unmuting an output makes the previous connection active as the crosspoint's state has
not been changed with the muting command, only the output was disabled.
8.4.11. Disconnect any inputs from one output
Description: Switch an output to virtual unconnected input. No signal on output.
Command {0@<out>}
Response (O<out²>●I00)CrLf
Explanation: Inputs are disconnected from output 5 (no input will be connected).
Info: The response for this command is (1LO<out²>) if the output is locked.
Info: Disconnecting acts similar to muting except that the previous connection cannot be
restored with an unmute command. A disconnected output can still be muted or unmuted,
however this has no real effect in this case.
Info: To make a disconnected output live again another input has to be switched to it.
8.4.12. Lock specified output
Description: Lock output <out>. Output's state cannot be changed until unlocking.
Command {#><out>}
Response (1LO<out²>)CrLf
Explanation: Output 5 is locked.
8.4.13. Unlock specified output
Description: Unlock output <out>. The connection on output can be changed.
Command {+<<out>}
Response (0LO<out²>)CrLf
Explanation: Output 5 is unlocked.
Info: The router issues the above response regardless of the previous state of the output
(either it was locked or unlocked).
Section 8. Programmer's reference
Format
Format
Format
Format
MX-FR series modular matrices
Example
→ {+03}
← (0MT03)CrLf
Example
→ {0@3}
← (O03 I00)CrLf
Example
→ {#>05}
← (1LO05)CrLf
Example
→ {+<05}
← (0LO05)CrLf
User's Manual
Page 107 / 137
Advertisement
Table of Contents
