Lcd Menu Pop-Up Messages - Lightware MX-FR9 User Manual

Config backup menu
Navigate to this menu in the main menu list and press
enter  or right ► button.
The full matrix configuration including every port setting
and EDIDs can be saved and reloaded later.
To
'Save config now!' and press enter  or right ► button. A
confirmation message appears then the progress starts.
A status indicator shows the progress. This may take up
to 1 minute. After the saving finished a message appears:
'Ready! 20120925-1536.cfg'
The configuration file name includes the date and time
when the configuration was saved in YYYYMMDD-HHMM format. For example the file
20120925-1536.cfg
September 2012.
To reload a previously saved configuration go to 'Config
to load' item with the up ▲ and down ▼ buttons and then
select the desired configuration file with the left ◄ and
right ► buttons. Press enter  to reload the selected
configuration. Note that this will change every setting in
the matrix (I/O port parameters, crosspoint presets, EDIDs, etc.) and the previous state
could be restored only if the configuration was saved earlier.
A confirmation message appears then the progress can
be started. This may take several minutes. A status
indicator shows the progress. After the configuration
reloading finished a message appears: 'Ready!' and the
matrix reboots.
Info: The matrix must not be switched off during configuration
reload process! If the power goes off then the matrix will
restart with factory default settings.

5.4.3. LCD menu pop-up messages

ALERT screen
This pup-up screen appears when a high level error
occurs in the matrix. Press the enter  button to dismiss
this alert and jump to the system log entry.
Use the up ▲ and down ▼ buttons to scroll between the
log entries.
Please contact Lightware support.
Section 5. Operation
save the current
was saved
MX-FR series modular matrices
configuration select
th
at 15:36 on 25
User's Manual
~Config backup
Config backup
~Save config now! >>
Config to load:
Preview output
Saving config!
14% ready
Config backup
Save config now!
~Config to load:
~< 20120925-0000
Load config file?
NO
~YES
Loading – 82%
Don't turn off!
~------------------~
|ALERT!
|FANSPEED
~------------------~
Log entries
7/8 Error
FANSPEED
p:0x01 o:3
Page 57 / 137
>>
[*]
~
>~
>>
|
|