Table of Contents
Advertisement
4.3. Front panel LCD menu operation
4.3.1. Menu concept
There are three operation modes of the LCD menu:
Normal mode
EDID mode
Signal Present mode
Press the Left or the Right button to jump between the menus and parameters Use the Enter
or Take buttons to enter a menu or execute an item. The Up and Down buttons modify the
values if modification is enabled.
Chapter 4. Operation
Most settings can be done in this mode. It activates after
powering on.
Use this mode to set up the emulated EDID on the inputs,
learn EDID form the outputs or to view the EDID memory.
This mode is activated when EDID button is illuminated. You
can enter this mode or exit by pressing the EDID button.
This mode is for checking the presence of the display devices
and incoming signals. It is activated when Signal Present button
is illuminated. You can enter this mode or exit by pressing
Signal Present button.
LCD menu
Normal mode
Default display
IP settings
Power status
Selftest
Error list
Installed cards
Firmware versions
Factory resets
EDID mode
EDID view
EDID save
EDID switch
Signal present mode
LCD menu structure
MX8x8HDMI-Pro series
IP address
IP port
IP subnet
IP gateway
Save & exit
Exit no save
IP reset
IO card reset
HDCP KEY reset
Disable HDCP on all inputs
Enable HDCP on all inputs
EDID reset
User's manual
Page 25 / 81
Advertisement
Table of Contents
