Left Tail Section And Battery Pan - Buell 2004 XB9S Service Manual

HOME

LEFT TAIL SECTION AND BATTERY PAN

DISASSEMBLY
1. Remove seat. See 2.41
11 1
WARNING
Always disconnect the negative battery cable first. If the
positive battery cable should contact ground with the
negative cable installed, the resulting sparks may cause
a battery explosion which could result in death or seri-
ous injury.
2. See Figure 2-113. Unthread fastener and remove battery
negative cable (black) from battery negative (-) terminal.
3. Pull back terminal cover boot on battery positive cable
(red).
4. Unthread fastener and remove battery positive cable
from battery positive (+) terminal.
5. Remove battery.
6. See Figure 2-113. Disconnect:
Wire harness ground (2) [GRD 2].
Rear brake light switch connector (5) [121].
ECM connectors (7) [10 & 11].
BAS (bank angle sensor) connector (9) [134].
Right turn signal connector (11) [19].
Left turn signal connector (10) [18].
License plate lamp connector (12) [45].
Tail light connectors (13) [93].
Ground terminals on right side tail section (6)
[GRD1] & [GRD 3].
Active exhaust system (1200 models only)
7. Remove the rear shock absorber reservoir. See
REAR SHOCK ABSORBER.
8. Cut cable strap loosely attaching BAS wire harness to
seat latch cable.
SEAT.
WARNING
9. See Figure 2-113.
from support bracket.
10. Move rear main harness and shock absorber reservoir to
right side of vehicle.
11. Remove left side passenger footrest support assembly.
See 2.30 FOOTPEG, HEEL GUARD AND
12. See Figure 2-113.
Left front trunk pan to left side tail section (14).
Left rear tail section to center tail section (15).
Left tail section to main frame/fuel tank assembly.
13. Remove left tail section from vehicle.
In order to remove trunk pan it will be necessary to remove
the following fasteners and components.
14. Remove two fasteners securing trunk pan to center tail
section.
15. See Figure 2-113.
trunk pan to right side tail section.
16. Remove right side passenger footrest support assembly.
See 2.30 FOOTPEG, HEEL GUARD AND
17. Slide trunk pan with battery pan, seat latch, bank angle
sensor, rear shock reservoir mounting bracket and ECM
out left side of vehicle.
18. Remove remaining components on trunk pan as needed.
CLEANING
2.22
Do not use wheel care products or other compounds
developed specifically for cleaning and polishing pow-
dercoat. These cleaners could potentially damage the tail
section finish.
The cast aluminum tail section has a powder coat. Because
the surface is not bare polished aluminum, it must be cleaned
using only mild soap and warm water. After washing, always
dry the surface using a clean, soft cloth.
Remove fuse block and relay center
MOUNT.
Remove the following fasteners:
NOTE
Remove fastener securing right front
MOUNT.
CAUTION
2004 Buell Lightning: Chassis
2.37
2-85