Left Tail Section And Battery Pan - Buell 2007 ULYSSES Service Manual

HOME

LEFT TAIL SECTION AND BATTERY PAN

DISASSEMBLY
1. Remove seat. See 2.45
11 1
WARNING
Disconnect negative (-) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explo-
sion, which could result in death or serious injury.
(00049a)
2. See Figure 2-127. Unthread fastener and remove battery
negative cable (black) from battery negative (-) terminal.
3. Pull back terminal cover boot on battery positive cable
(red).
4. Unthread fastener and remove battery positive cable
from battery positive (+) terminal.
5. Remove battery.
6. Remove center tail loop. See
7. See Figure 2-127. Disconnect ECM connectors (4) [10],
{11] and [164].
8. See Figure 2-127. Remove battery pan
a. Remove ECM (3).
NOTE
When removing the ECM, the fastener closest to the shock
assembly has a nut that is captured in the plastic shield below
the ECM. You need to place your finger under the nut when
removing the fastener to prevent the nut from falling out. Slide
the ECM to one side and loosely install the fastener to retain
the nut in the correct location. The rear fastener attaches
directly to the battery pan.
b. Disconnect rear brake light switch connector [121].
c. Disconnect and remove Bank Angle Sensor (2)
[134].
d. Remove fuse block and relay center (5).
e. Remove main harness and plastic grommet (7) from
battery pan.
f. Remove fasteners securing battery tray to left and
right tail sections.
g. Lift battery pan straight up and out.
9. Remove fastener securing left front trunk pan to left side
tail section.
10. Remove fasteners securing left tail section to main
frame/fuel tank assembly.
11. Remove left tail section.
12. Remove the trunk pan.
a. See Figure 2-127.
ing the preload adjuster to the trunk pan (13).
b. Remove the shock reservoir fastener and retainer.
Push the reservoir aside to access the fastener.
c. Remove remaining fasteners securing right front
trunk pan to right side tail sections.
d. Remove remaining components on trunk pan as
needed.
SEAT.
WARNING
2.42 CENTER TAIL LOOP.
Remove the two fasteners secur-
CLEANING
NOTE
Do not use wheel care products or other compounds devel-
oped specifically for cleaning and polishing powdercoat.
These cleaners could potentially damage the tail section fin-
ish.
The cast aluminum tail section has a powder coat. Because
the surface is not bare polished aluminum, it must be cleaned
using only mild soap and warm water. After washing, always
dry the surface using a clean, soft cloth.
2007 Buell Ulysses: Chassis
2.41
2-93