Qualification Of Personnel; Warranty Terms; Prohibition Of Unauthorized Conversions And Modifications; Specific Accessories Required For Safety Reason - Ametek burst NX8 Quick Start Manual And Safety Instructions

Surge, burst, damped oscillatory, telecom surge generators
Table of Contents

Advertisement

AMETEK CTS
Personnel fitted with a heart pacemaker must neither operate the instrumentnor approach the test setup
while a test is being executed.
CAUTION
Only approved accessories, connectors, adapters, etc. are to be used to ensure safe operation.
1.5.

Qualification of personnel

All listed devices must be operated only by authorized and trained specialists.
1.6.

Warranty Terms

AMETEK CTS provides this written warranty covering the product stated above, and if the buyer discovers and notifies
AMETEK CTS in writing of any defect in material or workmanship within the applicable warranty period stated above, then
AMETEK CTS may, at its option: repair or replace the product; or issue a credit note for the defective product; or provide the
buyer with replacement parts for the product.
The buyer will, at its expense, return the defective product or parts thereof to AMETEK CTS in accordance with the return
procedure specified below. AMETEK CTS will, at its expense, deliver the repaired or replaced product or parts to the buyer.
Any warranty of AMETEK CTS will not apply if the buyer is in default under the purchase order agreement or where the
product or any part thereof:
is damaged by misuse, accident, negligence or failure to maintain the same as specified or required by AMETEK
CTS;
is damaged by modifications, alterations or attachments thereto which are not authorized by AMETEK CTS;
is installed or operated contrary to the instructions of AMETEK CTS;
is opened, modified or disassembled in any way without AMETEK CTS's consent; or
is used in combination with items, articles or materials not authorized by AMETEK CTS.
The Buyer may not assert any claim that the products are not in conformity with any warranty until the buyer has made all
payments to AMETEK CTS provided for in the purchase order agreement.
1.7.

Prohibition of unauthorized conversions and modifications

The user is not entitled to the device to perform its own modifications and adaptations. Modifying parts on the generator by
unauthorized persons will void the warranty of the device and the correct functioning cannot be guaranteed.
1.8.

Specific accessories required for safety reason

Only use accessories approved by AMETEK CTS for these generators and intended as accessories for these devices.
Measuring instruments for the measurement of instrument parameters shall be designed for the maximum voltage and current
from the generator. Otherwise safety cannot be guaranteed.
1.9.

Procedure in case of hazard

If a hazard could exist due to an unintended condition of the generator, the following procedure is recommended:
Disconnect the device- and EUT power supplies from the power supply and ensure that the generator is always earthed via
the supply lines or a different ground connection. Wait at least 15 minutes and ground all outputs via a 10 kΩ, 15 W resistor.
Call an AMETEK service center.
1.10.

Temperatures at the surface

The components that generate heat in the device (resistors, etc.) are arranged inside the device in such a way that no
temperatures higher than 50 C occur on the surface.
1.11.

Lifting and carrying instructions

The generators usually weigh more than 20 kg. For lifting and carrying, two persons must always lift the equipment together or
use a suitable lifting device. The device must be gripped by the carrying handle and on the underside.
Quick start guide - Single pulse generators
1.00
8 / 88

Advertisement

Table of Contents
loading

Table of Contents