Ametek burst NX8 Quick Start Manual And Safety Instructions page 70

AMETEK CTS
1 "Test On"
2 Function keys "F1..F7
3 Display
4 Exit
9 LED mains coupling
The LED Indicate the actual coupling mode for the 1-phase or 3-phase.
10 EUT test supply
For single- or three-phase EUT the coupling/decoupling network is part of the generator. The EUT is powered via the safety
banana plugs at the front panel of the simulator
11 Fast damped output for I/O lines
Coaxial output plug for the fast damped oscillatory wave to a capacitive coupling clamp for testing I/O lines.
12 Direct HV and COM output
The HV and COM output are the designed for an external using of the impulse. This output is floating and is used for external
coupling/decoupling networks or magnetic field antenna.
The direct HV and COM output of the generator is located at the front panel of the instrument. It is not
allowed to connect these outputs to any other coupling/decoupling network than manufactured by AMETEK
CTS, e.g. the types CNV or CNI.
Before to connect any external networks to this output the operator must contact the manufacturer. Any
damages due to this matter are not covered by warranty.
The direct pulse output shall also not be used to connect the generator directly to any power conducting
Attention
lines.
5 Cursor keys "" and "→"
6 Knob (Inc. / Dec)
7 Escape
CRO trigger output  5V
8
1.00
Quick start guide - Single pulse generators
9 LED mains coupling 1/3 ph.
10 EUT test supply 1ph/3ph
11 Fast damped output for I/O lines
Direct output HV – COM
12
70 / 88