Ametek burst NX8 Quick Start Manual And Safety Instructions page 44

AMETEK CTS
1 Active indication
2 USB input (Memory stick)
3 Touch screen
4 Back
5 Knob (Inc. / Dec /Enter)
7 START / PAUSE / STOP button
- Green indication: Start or continues a test
- Orange indication: Pause of a running test
- Red indication: Stop a running or paused test.
8 CRO I (surge)
At the BNC output the current pulse (surge) of the generator can be measured galvanic separated. This output can be used
for get a fast overview. For accurate measurements please use external measuring devices.
- Impedance measuring instrument: >1MΩ.
- Max. output voltage: 10V 10% at 5.0 kA output current.
9 CRO U (surge)
At the BNC output the voltage pulse (surge) of the generator can be measured galvanic separated. This output can be used
for get a fast overview. For accurate measurements please use external measuring devices.
- Impedance measuring instrument: >1MΩ.
- Max. output voltage: 10V 10% at 20 kV impulse voltage.
10 BNC - CRO Trigger
At the BNC output the generator trigger can be checked for trigger a scope, (+5 V rectangular).
11 LED bar
Indicates the charging of the internal impulse capacitor.
12 EUT test supply
Generator surge output to the Adapter network is part of the generator. The EUT is powered via the safety banana plugs at
the front panel of the simulator.
6 " Test On"
7 Start / Pause / Stop
8 CRO I (surge)
9 CRO U (surge)
CRO Trigger output  5V
10
1.00
Quick start guide - Single pulse generators
11 LED bar for charging voltage
12 EUT test supply
13 Polarity selection
14 Range selection
15 Short circuit for load range
44 / 88