Table of Contents
Advertisement
AMETEK CTS
6.6.
Front view (model-specific distinctions)
1
Active indication
2
Touch screen
3
Knob (Inc. / Dec /Enter)
4
" Test On"
CRO Trigger output 5V
5
1
ACTIVE
Indicates that this unit is active
2
Touch screen and user interface
With the 7" capacitive touch screen display the user controls the equipment. The display indicates the status of the generator
and test equipment.
3
Wheel (Inc. / Dec / Enter)
Rotate for increments or decrements a selected parameter. Push changes the digit and hold with a numeric value or
selects from a list of parameters. Press to change adjustment range. Selected range will be shown briefly next to
selected parameter. Push and hold to "zero" to nearest range.
4
Test On
After pressing the "Test On" key, the following actions are activated:
- Activate the high voltage power unit; HV is ready to start.
- Switches ON the supply to the EUT test supply.
5
BNC - CRO Trigger
The generator trigger can be checked at the BNC output, e.g. the burst duration, the burst repetition rate and the spike
frequency (+5 V rectangular). This output can be generally used as oscilloscope trigger output and is synchronous to the
following event.
- Burst release.
HV pulse Burst output 50
6
7
EUT test supply
8
Ground reference (calibration)
9
Start / Pause
10
Stop
1.00
Quick start guide - Single pulse generators
11
Back
12
AC / DC test supply
Coupling mode (50 output)
13
14
Coupling mode (supply lines)
15
USB input (Memory stick)
24 / 88
Advertisement
Table of Contents
