Rear View Ocs 500N6F.x - Ametek burst NX8 Quick Start Manual And Safety Instructions

AMETEK CTS
10.6.

Rear view OCS 500N6F.x

1 EUT supply input neutral
2 EUT power mains supply line
3 Sync input
4 Test supply input PE
5 Reference earth connection
6 Warning lamp
7 Ventilation
8 Safety Circuit
1 EUT power mains supply input - Neutral
The neutral N is conducted to the EUT via the coupling/decoupling network to the front panel output N.
2 EUT power mains supply input - Phase
The phase of the power mains supply for the EUT is connected to the lack banana connector L. The 3-phase device has all
power mains supply ports on the lower part at the rear side.
3 SYNC input
Input port for ac voltage pulse synchronization to the mains. If no voltage is available the tests will start automatically in
asynchronous mode. Normally the Sync input shall be connected directly from the L power mains input (2) of the EUT. The
input voltage range is 10..250 Vac
EUT power mains supply input – Protective Earth (PE)
4
The protective earth PE is conducted directly to the front panel output PE.
5 Reference earth connection
The generator must be connected to the reference earth plane of the test set up.
6 Warning lamp
A voltage free contact is available for external warning indications (warning lamp). The relays contact (250V / 5A) will switch
after pressing TEST ON button.
7 Ventilation
After long term duration tests the generator should keep on running for some minutes to cool down the system.
8 Safety circuit
A test can only be started if the safety circuit is closed. By opening the safety circuit during a running test, the test will be
stopped immediately and the high voltage will be switched off and grounded. For s
The safety circuit will not switch off the EUT Mains supply. For switch off the EUT mains a similar safety circuit must be used
as described in a rack solution in the safety manual.
Quick start guide - Single pulse generators
1.00 71 / 88