Table of Contents
Advertisement
AMETEK CTS
6.7.
Rear view (model-specific distinctions)
1
AC EUT supply input
2
DC EUT supply input
3
Ventilator
4
Mains Switch
5
External Trigger IN
6
Fail, EUT 1, EUT2
1
AC EUT supply Input
Input plug for the AC EUT power supply (4mm safety banana plug). The input is not fused.
- Lx:
Mains voltage to EUT phase/phases
- N: Neutral to EUT supply
- PE:
Protected earth to EUT supply
- Rated power:
1-phase max. 400 V AC (L-N), 16 or 32 A depending on the model
3-phase max 3 * 690 V AC (L-L), 16 or 32 A depending on the model
2
DC EUT supply Input (burst NX8 xx.1-models only)
Input plug for the DC EUT power supply (4mm safety banana plug). The input is not fused.
- +:
Positive pole to EUT
- -:
Negative pole to EUT
- PE:
Protected earth to EUT; Use PE-Input from AC EUT supply Input if required
- Rated power:
max. 1.000 V DC, 16 or 32 A depending on the model
3
Ventilation
A power-controlled ventilator is cooling the burst NX8 generator. During the most application the ventilator runs with variable
speed depends on the cooling requirement. After long term duration tests the generator should keep on running for some
minutes to cool down the system.
4
Power ON Switch
Wide range mains input (84 V – 254 V 50/60 Hz) for the device control. The switch is part of the mains filter. Mains fuses are
part of the filter. (@ 230V / 2AT and @ 115V / 4AT)
7
USB A interface
8
USB B interface
9
Ethernet interface
10 Opto Link Interface
11 Sys Link OUT
12 Sys Link IN
1.00
Quick start guide - Single pulse generators
13 Sync input
14 Mains input device
15 Reference earth connection
27 / 88
Advertisement
Table of Contents
